Where Does Ground of Bulldog Powered-Drive Kit for Single-Speed Jacks # BD1824200100 Go To
Question:
Where does the ground go on the wiring harness?
asked by: Christopher
0
Expert Reply:
The ground of the Bulldog Powered-Drive Kit for Single-Speed Jacks # BD1824200100 needs to run to the ground stud of the junction box that comes with it. This would then run to the ground of the trailer battery.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Powered-Drive Kit
- Bulldog
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Installation Instructions for Bulldog Powered-Drive Kit # BD1824200100
- Q&A: Replacement Trailer Hub/Drum for Part Number 2420801
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Kit to Convert 2021 Vanleigh Pinecrest 335RLP to Electric Over Hydraulic Disc Brakes
- Q&A: How To Charge 12v Batteries Wired in Parallel
- Q&A: What are the Dimensions of a #99 Spindle
- Q&A: Using NOCO 2 Bank Charger With Parallel Batteries in Truck
- Q&A: Recommended 7000lb Leaf Springs To Replace Dexter 072-027-00
- Article: Trailer Wiring Diagrams
- Article: Trailer Hitch Receiver Sizes
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Stability Control for Heavy Duty Vehicles
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Testing Trailer Brake Magnets for Proper Function