BulletProof Hitches 2-Ball Mount - Do I Just Flip It Over To Use The Rise?

Question

Question:

I bought the bullet proof two ball 4 1/4” 4 3/4” rise system. Stupid question, do I flip it over for the rise? Angle and gusset on top

asked by: Paula L

0

Expert Reply:

You are exactly right. To use the Bulletproof ball mount # BPH64FR in the rise position you simply flip it over. The picture below will show you an example of the ball mount in the rise position.

expert reply by: Jesse M

0

Bulletproof Ball Mount In Rise Position
(click to enlarge)

Answer 1

To install the Torklift hitch part #TLF1000 you will need to drill holes in the frame for all of the included bolts to fit through. Typically what people will do is position the hitch up where it needs to go and then either drill through the holes in…

view full answer...

Answer 2

That's going to depend a lot on the trailer setup as well which we can't know but what we do know is that the BulletProof Hitches like the part #BPH64FR have a longer distance between the center of the pin hole and the ball center so if there…

view full answer...

Answer 3

This is a reason we measure and label our site all the same way rather than going off the description or title from our manufacturers. On the BulletProof Hitches 2-Ball Mount #BPH64FR it is capable of a 4" total drop or 4" total rise. The…

view full answer...

Answer 4

The total height of the B&W Tow & Stow 2-Ball Mount - 2" Hitch - 3" Drop, 3-1/2" Rise item #BWTS10033B is 6 1/2". I have attached a picture with the dimensions drawn on it.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

From the top of the shank to the bottom of the vertical section of the B&W Tow & Stow 2-Ball Mount #BWTS10040B measures 10". Then with the 2" hitch ball in the lowest position the 2-5/16" hitch ball will sit about 12"…

view full answer...

Answer 7

The B&W Tow & Stow 2-Ball Mount part #BWTS10037B will measure 9.5" from the top of the shank to the bottom of the hitch ball while in the lowest settings.

view full answer...

Answer 8

Yes, it is. The Jensen LED 12V RV TV item #JTV1917DVDC has an HDMI port in the back which is what you will need to connect a Firestick or ROKU. You'll definitely need to use that HDMI extension cord that comes with the Firestick though.…

view full answer...

Answer 9

The angle of the arms that hold the flaps of the Rock Tamers Heavy-Duty, Adjustable Mud Flap System #ERT00108 are adjustable so that you can add distance between the tail pipe and them as needed. If you install the heat shield part #RT76FR that you…

view full answer...

BulletProof Hitches 2-Ball Mount - Do I Just Flip It Over To Use The Rise?

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching