Adjustability of Enclosed Trailer Ramp Spring
Question:
In looking at the detailed drawing for this unit, I see a lot of unused axle in the middle. Does this allow for some width adjustability? My trailer opening falls just short of the 81.
asked by: Scott W
Helpful Expert Reply:
I spoke with my contact at M-3 who said the ramp spring shaft can be cut down to a maximum of 62 inches and you would still have room to wind the springs. The shaft is made of steel tubing so the proper saw or power saw blade would cut through it. Be sure to get a straight cut and file down the rough spots.
The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install this system.
Product Page this Question was Asked From
Conventional Ramp Door Spring for 7' Wide Enclosed Trailer - Dual Spring - 120-lb Capacity
- Trailer Ramp Springs
- Dual Ramp Spring
- Conventional
- 120 lb Capacity
- 81 Inch Wide Spring
- 84 Inch Wide Doors
- Steel
- M-3 and Associates
more information >
Continue Researching
- Shop: Trailer Hitch
- Shop: Conventional Ramp Door Spring for 8' Wide Enclosed Trailer - Dual Spring - 250-lb Capacity
- Search Results: ramp door spring
- Search Results: door hinge
- Search Results: pk11893
- Search Results: fastway
- Search Results: jack
- Shop: Grease Cap, 1.99" OD EZ Lube Drive in with Plug - Qty 2
- Shop: Locknut for Trailer Shackle Bolt - 1/2" Diameter - Zinc Plated
- Shop: Rubber Bumper for Enclosed Trailer Ramp Door - 2-1/2" Diameter
- Shop: Conventional Ramp Door Spring for 7' Wide Enclosed Trailer - Dual Spring - 120-lb Capacity
- Shop: Fastway Zip Trailer Breakaway Switch with Coiled Cable - 4' Long
- Shop: Battery Tray with Strap - Group 31 Battery - 14" x 8-3/8"
- Search Results: hm20041
- Search Results: battery tray
- Shop: Gooseneck Hitch
- Shop: BOLT brand vehicle and hitch locks
- Shop: Trailer Wiring
- Shop: Vehicle Air Mattress
- Q&A: What are the Dimensions of the Enclosed Trailer Ramp Spring ERS120D81
- Video: Review of TRC Enclosed Trailer Parts - 36279-955
- Shop: RV Roof Membrane
- Shop: Nerf Bars - Running Boards
- Q&A: Can TRC Enclosed Trailer Ramp Spring Be Cut Down
- Q&A: Sizing of Ramp Springs
- Q&A: Picking Out Replacement Axle for Snowbear 550LHD Trailer
- Q&A: Ramp/Door Spring Recommendation for 2011 Homesteader Enclosed Trailer
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: How to Correctly Position Ramp Door Spring for Installation
- Q&A: What Info Is Needed to Pick Out Conventional Trailer Ramp Spring