Will the Bulldog Powered Drive Kit for Single Speed Jacks fit a 10K Jack
Question:
Will this kit BD1824200100 fit the Bulldog BD180405? It is a square tube side wind10k jack. Jack is about 1 year old.
asked by: Eric
0
Expert Reply:
Unfortunately no, the Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity # BD1824200100 is not going to work with your Bulldog BD180405 10K jack.
This kit is sonly going to work with single speed 12K jacks, so your best bet is to replace your setup with a set of electric jacks like the Ultra-Fab Deluxe Electric Landing Gear Set # UF17-943010.
expert reply by:
Bryce D
0
Products Referenced in This Question
Ultra-Fab Deluxe Electric Landing Gear Set - 38" Lift - 12,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- Landing Gear
- 38 Inch Lift
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Product Page this Question was Asked From
Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Powered-Drive Kit
- Bulldog
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Measure a Trailer Axle
- Q&A: Can the Rain Sensor on a MaxxAir Vent be Overridden
- Q&A: Installation Instructions for Bulldog Powered-Drive Kit # BD1824200100
- Article: Trailer Tire Sizing
- Q&A: Replacement Entry Door Lock On A 2004 Featherlight Horse Trailer
- Q&A: Bulldog Powered-Drive Kit Compatibility With 12K Ram Landing Gear
- Q&A: What is Minimum Clearance Between Gooseneck Trailer Overhang and Truck Bed Rails
- Q&A: Troubleshooting Trailer Tires that Rub on Trailer Frame After Axle Swap
- Q&A: Wiring Diagram for Dometic Single Zone Thermostat and Control Box
- Article: Pintle-Hitches
- Article: Trailer Wiring Diagrams
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: Trailer Maintenance Schedule
- Article: How to Measure for Trailer Hitch Drop