Will The Horst Miracle Probe Sensors # T21301VP Fit Into 3/8" Threaded Holes on Valterra Water Tank?
Question:
Is there a way to use the existing 3/8 threaded holes on the valterra tanks to receive the valterra probes? If not, where eould be the most appropriate place to install them? End wall or side wall?
asked by: Ty
0
Expert Reply:
Yes, the Horst Miracle Probe Sensors # T21301VP will fit into the existing 3/8" threaded holes on your Valterra tanks. The probes will push into the holes and you will tighten the first nut to create a leakproof seal.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Horst Miracle Probe Sensors for RV Black Water Tanks - Qty 4
- Smart RV
- Monitoring System
- Water Tanks
- No Display
- Valterra
more information >
Continue Researching
- Q&A: Replacing Black Water Tank Sensors
- Q&A: Wiring An Atwood RV Water Heater With Double-Panel On/Off Switch
- Q&A: Replacement Remote For a HappiJac Electric Camper Jack System
- Q&A: Wiring Replacement 7-Way Connector on 2004 GMC Yukon Denali
- Q&A: Programming Replacement Lippert LINC Remote
- Q&A: Recommended Roof Coating For EPDM Roof Membranes
- Q&A: Fixed Side Vs. Float Side for Replacement Standard Dual Rack Repair Kit Wall Slide-Out
- Article: Trailer Wiring Diagrams
- Article: Ram Trailer Tow Prep Package
- Article: Flat Towing Package for 2015 Ram 1500
- Article: Trailer Maintenance Schedule
- Article: Determining Trailer Tongue Weight
- Article: How Much Solar Power Do I Need For My RV?
- Article: Which RV Propane Tank Size Do I Need?