Will The Ultra-Fab Deluxe Landing Gear Set Fit A 1995 Fleetwood Terry 5th Wheel Trailer
Question:
Ultra-Fab Deluxe Electric Landing Gear Set - 38inch Lift - 12,000 lbs Will these fit by 1995 Terry by Fleetwood
asked by: Michael D
0
Expert Reply:
It's hard to tell where your weld stops are in the picture to get a confirmation. The Ultra-Fab Deluxe Electric Landing Gear Set # UF17-943010 would need the weld stops to be placed 13.5" from the top of the top weld stop to the top of the bottom weld stop in order to reuse your mounting brackets. If you do not have a 13.5" measurement then you'd need to cut the brackets off and weld on the new ones included with the kit.
expert reply by:
Kevin C
0
Measurements
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Ultra-Fab Deluxe Electric Landing Gear Set - 38" Lift - 12,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- Landing Gear
- 38 Inch Lift
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Brake Assemblies and Hub/Drums for 15k Dexter Axle
- Q&A: Replacement Trailer Wheel for Dexstar Wheel 17-293
- Article: Replacement Automotive Lighting
- Q&A: How Many Transfer Switches are Needed to Switch from Shore Power to a Genreator, and An Inverter?
- Q&A: Wiring Instructions For The Furrion Automatic Transfer Switch
- Article: How to Charge a Dump Trailer Battery
- Article: Trailer Hitch Receiver Sizes
- Article: Trailer Tire Sizing
- Q&A: No Turn or Brake Signals on Trailer on a Jeep Liberty with Tow Ready Harness 118524
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Grease Seal to Replace 127194TB
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Article: Calculating Portable Generator Power Needs
- Article: Testing Trailer Brake Magnets for Proper Function