Recommended Mounting Bracket for a Fulton F2 Trailer Jack
Question:
I have a F2® Marine Trailer Jack, 1,600 lbs. Lift Capacity which was from my previous trailer which had a 4inch channel and my current trailer is 5. Can I purchase a mounting plate which will accommodate a 5inch channel? I would like to be able to utilize my existing jack. On the fulton site, it says: Available in bolt-on and weld-on versions for up to 5inch tongues. It is item 1 on the parts list. Thanks for your help.
asked by: Bob
Expert Reply:
What you're looking for is the Fulton Adapter Kit # F500320. All the mounts according to Fulton will fit up to a 5" trailer frame so you'll be all set.
Product Page this Question was Asked From
Fulton Adapter Kit - Weld-On XP Jack Mount to F2 Swing-Up Trailer Jack for 3" x 4" Frames
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Plates
- Fulton
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Solution for Atwood Surge Brake Coupler Needing Replacement Parts
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Closest Metric Replacement Tire Size for 7.00-15 Tire on Livestock Trailer
- Article: Pintle-Hitches
- Q&A: Reese Extension/Reducer # RP45292 Compatibility with Class V Factory Hitch on 2013 Ram 2500
- Q&A: Trailer Hitch Extension to Tow Motorcycle with 2012 Chevy Silverado 2500 with Lance Camper
- Article: Brake Controller Installation: Starting from Scratch
- Article: Big Truck Big RV
- Article: Most Popular Wheel Bearings
- Article: Best Boat Trailer Jacks