Does Roller of CE Smith Keel Roller assembly part # CE32005G Need to be Replaced with Bolt and Nut
Question:
One of the reviews claims the main axle end cap clamps came off the center pin and that a bolt and nylock should be used instead. Interested in your response. Thank you.
asked by: Mark M
1
Helpful Expert Reply:
In general the CE Smith Keel Roller assembly part # CE32005G works really well as-is and does not require replacing the roller with a bolt and nylock washer. That could potentially work but I would not recommend that as a requirement at all.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
CE Smith Keel Roller Assembly for 2" Wide Trailer Tongues - Galvanized Steel and Black Rubber
- Boat Trailer Parts
- Rollers
- Keel Roller
- 11-1/2 Inch Tall
- Black Rubber
- 4 Inch Long
- CE Smith
more information >
Continue Researching
- Q&A: Where Can Winch Mount and Bow Roller Mount on CE Smith Multi Sport Plus Boat Trailer 48870
- Q&A: Recommended Replacement for Model 70LP Surge Brake Actuator
- Q&A: Does The Redline Grease Seal 13194 Have Markings Of TCM 13194 TM and a Spring On The Inside Lip
- Q&A: Difference In Factory Lifestyle Hitch And Frame Mounted Hitch 2021 Kia Seltos
- Q&A: Correct Replacement 1,200 lb Spring Bars for the Blue Ox 2-Point WDS
- Q&A: Adding Rollers, a Winch, and Straps to a Malone MicroSportXT
- Q&A: Recommended Winch Stand For Flat Trailer With Single Beam Tongue
- Article: How to Choose the Right Trailer Hitch Class
- Article: Double-Eye Trailer Suspension System Review
- Article: Trailer Tire Sizing
- Article: Trailer Lighting Requirements
- Article: Determining Trailer Tongue Weight
- Article: Measuring a Trailer Tire
- Article: What is Boondocking