How to Tell if a Dexter Axle Hub and Drum Kit Fit a 1997 Elite Trailer
Question:
I have a 97 Elete trailer model 18SAB. Would this be the correct assembly?
asked by: Jon
Expert Reply:
As long as the hubs on your 1997 Elite Trailer use the bearings and grease seal listed below then yes, the Dexter Trailer Hub & Drum Assembly for 3,500-lb Axles # 84546UC3-EZ will work:
- Inner Bearing # L68149
- Outer Bearing # L44649
- Grease Seal 10-19 (1.719" ID)
About 2000 is when trailers started to sort of us standardized parts which is why it's important to check your bearings and grease seal for compatibility.
Products Referenced in This Question
Replacement Trailer Hub Bearing - L44649
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.063 Inch I.D.
- Bearing L44649
- Race L44610
- 3500 lbs Axle
- etrailer
more information >
Replacement Trailer Hub Bearing - L68149
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.378 Inch I.D.
- Bearing L68149
- Race L68111
- 3500 lbs Axle
- etrailer
more information >
Product Page this Question was Asked From
Dexter Trailer Hub & Drum Assembly for 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 - Pre-Greased
- Trailer Hubs and Drums
- Hub with Integrated Drum
- Pre-Greased
- Standard
- L68149
- L44649
- For 3500 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Continue Researching
- Shop: Dexter Trailer Hub & Drum Assembly for 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 - Pre-Greased
- Shop: Dexter Trailer Hub and Drum Assembly for 3,500-lb E-Z Lube Axles - 10" Diameter - 5 on 5-1/2
- Article: Most Popular Wheel Bearings
- Article: How to Measure the Bolt Pattern of a Trailer Wheel
- Article: Trailer Wiring Diagrams
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Can Trimax Puck Lock for Trailer Door Hasps be Keyed Alike
- Article: Trailer Tire Sizing
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Q&A: Recommended U-Bolts And Plate For A 1-1/2" Wide Square Axle
- Q&A: Can Electric Brakes be Used on a Boat Trailer
- Q&A: Is Additional Grease Needed to be Pumped into Dexter Trailer Hub that is Pre-Greased
- Q&A: Dexter Replacement Hub/Drum Assembly # K08-247-1G
- Q&A: How to Determine the Size of a Trailer Hub Assembly for Replacement
- Q&A: Replacement Hub & Drum For UFP HD-1377-10 & Hydraulic Brakes For Boat Trailer