How Is the Polar T-Handle Latch Supposed to Install
Question:
I dont see any mounting features on this latch?
asked by: Todd L
1
Helpful Expert Reply:
The T-Handle Latch # PLR5710 is meant to install into toolboxes that have pre-existing tracks and a cutout for the handle so it'd utilize the existing hardware for install.
expert reply by:
Bryce D
1
Product Page this Question was Asked From
- Accessories and Parts
- ATV-UTV Tool Box
- Trailer Tongue Box
- Trailer Tool Box
- Truck Tool Box
- Underbody Tool Box
- Handles and Latches
- T-Handle Latch
- Polar Hardware
more information >
Continue Researching
- Q&A: Replacment Motor for Pump Assembly on Lippert LCI Pump 650057
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Installation Questions Progressive Dynamics PD4100 Power Control Center
- Q&A: Replacement Slam Latch Solution For A TriMark 060-0460
- Q&A: Dimensions of Polar Hardware T-Handle Latch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Air Pressure Rating for a 4.80-12 Load Range C Trailer Tire
- Q&A: Dimensions of Compression Latch # 313-8-325-281 for RC Manufacturing Z-Series Truck or Trailer Box
- Q&A: Locating Replacement Shroud for Coleman 8333-8764 Air Conditioner
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Best RV Roof Vents
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: How to Choose a Trailer Hitch Coupler