Landing Gear With Dual Motors For Keystone 5th Wheel
Question:
I have a 2015 keystone avalanche the original landing gear Ive been told that I can change out the following leg with a lead leg and add a motor in a kit so that I could operate the legs independently and can you tell me what part numbers I would need to accomplish this
asked by: Jeffrey L
Expert Reply:
With connected landing gear you can't swap out the follow leg for a lead leg and motor to operate them independently. The gear wouldn't work and you wouldn't be able to orient the leg properly either. So you'd need to switch landing gear completely to an independent dual leg setup, the Ultra-Fab Deluxe Electric Landing Gear Set # UF17-943010.
Product Page this Question was Asked From
Ultra-Fab Deluxe Electric Landing Gear Set - 38" Lift - 12,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- Landing Gear
- 38 Inch Lift
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Complete AC System With An Advent 13.5K BTU Low Profile AC Unit
- Q&A: Correct Replacement for Atwood 71119 Landing Gear Motor
- Q&A: Diameter of Replacement Hinge Pin # 362TRCHingePin2
- Q&A: Atwood 87701 landing gear switch replacement
- Q&A: Are Replacement Parts for Atwood Landing Gear Available or Will Another Brand Fit
- Q&A: Recommendation for Replacing Bevel Gears for Atwood Landing Gear or Replacing Entire Landing Gear
- Q&A: What Does Code L. Mean on Curt Triflex Brake Controller
- Article: Best Landing Gear
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How Much Solar Power Do I Need For My RV?
- Article: Does Solar Panel Type Really Matter?
- Article: Trailer Tire Sizing