Where Does the Insulation Foam Go When Installing the Advent Air RV Air Conditioner
Question:
I changed AC units to a Advent using a ACRG15 distribution box with a wall mounted thermostat. Is there a diagram to where the diverter and several sticky back foam pieces need to be installed?
asked by: Mike
0
Expert Reply:
The stick black foam pieces should be installed inside the hole where the AC sits to help seal the area. The diverter box wiring diagram you're looking for I have attached below along with the functions of the wires.
If you have any other questions feel free to come back and we'll take care of you.
expert reply by:
Bryce D
0
Product Page this Question was Asked From
Advent Air RV Air Conditioner - 13,500 Btu - White
- RV Air Conditioners
- AC Unit Only
- Cool Only
- 13500 Btu
- Advent Air
- Dometic
- Ducted
- Ductless
- White
- Advent Air
more information >
Continue Researching
- Q&A: Can B and W Companion Slider From Ram Truck be Used in 2024 Chevy Silverado 3500
- Q&A: Can Aftermarket Puck System Be Installed on a 2024 GMC Sierra 3500
- Q&A: Wiring Diagram for the Replacement Digital Relay Box for Advent AC
- Q&A: Replacement AC Shroud for Dometic Duo Therm PDX 57915.622
- Q&A: Replacement for Coleman-Mach AC on 2001 Wilderness Camper
- Q&A: Recommended Tire Pressure Monitoring System for a 30 Fifth Wheel Trailer
- Q&A: Recommended Replacement For A Dometic Duo-Therm Rooftop Unit
- Article: How to Dump Black and Gray RV Waste Tanks
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: What Size Generator Do You Need to Run an RV Air Conditioner?
- Article: How to Mount a Truck Bed Camper
- Article: Trailer Tire Sizing
- Article: How to Replace or Install an RV Roof Vent
- Article: The Best 5th Wheel Hitches