No Running Lights & Weak Signals on Trailer When Installing New Lights
Question:
I just installed a new set of led tail lights on my 2013 Jayco Jayflight 22FB. The trailer on the left side has 4 wires 2 green, one red, one black , the left side has the same except only 1 green. The led light is a two section light and has has 80 diodes, 40 on each side of the single light My running lights do not work at all and when I turn on the head lights of my truck the turn signals and brake lights are really weak What do I do?
asked by: David L
Expert Reply:
This is definitely a case of a bad ground. So what I would do is try grounding the # DG52720PB lights you have directly to the trailer frame using a ring terminal and self-tapping screw. Make sure the frame is bare metal and clean, without any dirt, paint, etc.
Product Page this Question was Asked From
LED Trailer Tail Light w/ Reflector - Stop, Tail, Turn - Weatherproof - 80 Diodes - Red Lens
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Rectangle
- Surface Mount
- Non-Submersible Lights
- LED Light
- 11L x 8W Inch
- Red
- Diamond
more information >
Continue Researching
- Q&A: Power Draw of Diamond LED Trailer Tail Light w/ Reflector
- Q&A: Which is Brighter RV Taillight Command or Diamond Trailer Taillights
- Q&A: How Many Tail Lights Come with Diamond LED Trailer Tail Light w/ Reflector DG52720PB
- Q&A: Does the LED Trailer Tail Light 328-003-81LBM1 Require Resistors
- Q&A: Brightest Surface Mounted Trailer Tail Lights
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Bearings and Seals Based On Printed Number On Face Of Bearing
- Q&A: How To Install the ThinLine LED Light As An Identification Light On Trailer Over 80 Wide
- Article: Anti-Rattle Devices
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Overview of Lubricating Grease
- Article: Replacement Automotive Lighting
- Article: How to Mount a Truck Bed Camper