Jam Nut Size of Exact Center Stabilizer
Question:
What is the size of the locking nuts?
asked by: Dan
0
Expert Reply:
The locking/jam nuts on the Roadmaster Exact Center Steering Stabilizer # RM72ZR are 1/2" so you will need a 13/16" wrench for that.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Roadmaster Exact Center Steering Stabilizer
- Anti-Sway Bars
- Steering Stabilizer
- Mounting Hardware Not Included
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Vehicle Sway Bars
- Q&A: Does HBA-CAM Adapter Module for Hydrastar Electric Over Hydraulic Brake Actuators have 2 or 4 Wires
- Q&A: Replacement Microwave Convection Oven for Apollo Unit
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Q&A: Solution for Suspension Sag on 2016 Toyota Highlander Towing Trailer
- Q&A: Will Coil SumoSprings Custom Helper Springs Fit a 2018 Toyota Highlander
- Article: RV Cell Boosters, How Do They Work?
- Q&A: How Many Transfer Switches are Needed to Switch from Shore Power to a Genreator, and An Inverter?
- Q&A: Recommended Hub For Mobile Home Axle That Uses L68149 and LM67048 Bearings
- Article: Stability Control for Heavy Duty Vehicles
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: What is Overlanding? How to Start your Overlanding Journey
- Article: Cleaning Your RV Gray Water Tank in 5 Easy Steps
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride