Should Caliper Guide Bolts of Kodiak Disc Brake Kit Touch Brake Rotor
Question:
Are the caliper guide bolts supposed to contact the back of the rotor surface when installed and torqued to 40-50 ft/lbs? Referencing part #: K2HR35D for the Kodiak 225 calipers and 10” rotor/hub assembly
asked by: Brandon
0
Expert Reply:
The caliper guide bolts are not supposed to contact the rotor surface when they are installed.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Kodiak Disc Brake Kit - 10" Hub/Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- LH
- RH
- 3500 lbs
- Brake Assembly
- 5 on 4-1/2
- Hub and Rotor Assembly
- Kodiak
more information >
Continue Researching
- Q&A: Will 3,500 lb Kodiak Disc Brake Kit Fit 2012 EZ Loader Boat Trailer
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Most Popular Wheel Bearings
- Q&A: How to Convert Drum Brakes to Disc Brakes on a 2005 Boat Trailer
- Q&A: How to Determine if Trailer has 84 Spindle to Pick Out Replacement
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: Replacement for Global Direct GDC80 Brake Actuator
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Why Were The Kodiak 204 Calipers and Pads Discontinued?
- Q&A: How do etrailer Brand Trailer Brake Assemblies Compare to Lippert and Dexter
- Q&A: How To Choose Correct MORryde Shackle Upgrade Kit