Determining Torque for Trailer Suspension Components

Question:

Hello, Just installed the dexter EZ 6000 lb kit on my trailer. I had a question about tightening the bolts. You need to tighten them so the splines sink into the bracket, used a impact till head barely touched bracket, any concern with over tightening. I checked torque and they were already there? The shackle seam to move freely, not so sure about the front and rear shackles for the springs. I guess just concerned..... Thank you for your response

asked by: Mike K

Expert Reply:

You're good. You want them tight enough that they won't back off but not so tight that the suspension isn't allowed to move like where you are right now.

expert reply by: Jameson C