Are Replacement Bolts Available for the Curt Cargo Carrier?
Question:
I love my hitch and cargo thingy. My question is: The holes that the supplied bolts are to screw in were so rusted that one bolt broke when I tried to get it on. Do you sell Plusnuts that would accomodate the bolts? I will need to drill out the rusty ones first.
asked by: Jeff P
Expert Reply:
The 24x60 Curt Cargo Carrier for 2" Hitches # C18152 does not have replacement hardware available but it just uses 3 M12 x 75mm hex bolts which you can find in any local hardware store.
Since you're needing to also drill out the hole, you'd need to use a 1/2" bit # PTW8589. This will make the hole slightly larger since metric and imperial aren't 1:1, but its close enough to not be super noticeable.
Products Referenced in This Question
1/2" Titanium Drill Bit - Qty 1
- Hand Tools
- Drill Bits
- Standard Bits
- 1/2 Inch
- Titanium Coated Steel
- Performance Tool
more information >
Product Page this Question was Asked From
24x60 Curt Cargo Carrier for 2" Hitches - Steel - 500 lbs
- Hitch Cargo Carrier
- Flat Carrier
- Fixed Carrier
- 24 Inch Wide
- Heavy Duty
- Fits 2 Inch Hitch
- 60 Inch Long
- Class III
- Class IV
- Steel
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Comparing Curt and Reese Hitch Mounted Cargo Carriers
- Article: Rooftop Cargo Carriers
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: What is the Best Hitch for a 2024 Subaru Outback?
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Does Xtreme Off-Road Trailer Jack Come With Bearings Installed
- Q&A: Dimensions of Curt Cargo Carrier 18113
- Q&A: Caliper Bolts for AL-KO/Hayes Disc Brake Caliper BP18-050
- Article: Basics of Tie Down Straps
- Q&A: Distance From Pin Hole to End of Shank on Curt Cargo Carrier part # C18151
- Article: Trailer Wiring Diagrams
- Article: What Do I Need To Tow A Trailer?