How to Reset Zero Point on the Lippert Ground Control 3.0
Question:
i have 2016 cedar creek fifth wheel lippert six point hydraulic system worked really good until last winter battery went dead now nothing work as it did before. when auto leveling right rear jack lifts wheels off the ground other jacks dont raise the rv until the right jack is extended as far as it can go. another is when preparing to leave the camp site push button to retract slides and all rear jacks will come up before slides will come in. sometimes when i start to raise the front it retracts instead of extending. i have searched the internet and didnt find anyone with any of these problems. thanks for your help.
asked by: Freddie
Expert Reply:
I spoke with Lippert about your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote # LC358590 and they suggest that you try and reset your zero point.
To do this, you'll need to:
1. Set a carpenter’s level on the floor inside the unit and use the manual controls to manually level the unit
according to the carpenter’s level. Do this for front to back and side to side level.
2. Once the unit is level, press the “ON/OFF” button to turn off the interface.
3. With the interface turned off, press and release the “FRONT” button 10 times and then press and release
the “REAR” button 10 times.
The interface will flash and beep, and the display should read “ZERO POINT CALIBRATE”. To set this position in the memory, press “ENTER”.
Attached is a snippet from the instructions that shows this for you to check out as well.
If that does not fix it, feel free to come back and we can try some other troubleshooting.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How to Reset Zero Point Calibration on Lippert Ground Control 3.0
- Q&A: Is The Pad For The Replacement 22-1/2" Legs For The Ground Control 3.0 Welded Or Pinned In Place
- Q&A: Wiring Diagram for 5th Wheel Trailer Landing Gear with Red, Black, White, and Green Wires
- Q&A: Wiring Guide for Installing 5th Wheel Landing Gear Motor Switch
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Can I Install a 4-Point Control Module to a 6-Point Lippert Ground Control and Only Use Four Jacks?
- Q&A: Drawing Schematic of Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Article: How to Raise Your Travel Trailer Height
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Double-Eye Trailer Suspension System Review