How to Remove Side Clearance Light with Nut That is Fixed to Threads on Bolt
Question:
Hi, I want to purchase a set of these but im having trouble getting the originals off. they are rusted and the whole threads turn instead of just the nut. any ideas?
asked by: Jeffrey H
0
Expert Reply:
Since the nut on the back of your Square Trailer Clearance and Side Marker Light with Reflex Reflector # MC37AB is seized to the bolt I recommend removing the face of the light (the two screws at the front) so you can then secure the bolt on the inside while you loosen up the nut at the back.
You shouldn't have to go through this process when you install the new lights though.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Square Trailer Clearance and Side Marker Light with Reflex Reflector - Amber
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 2-7/8L x 2-1/8W Inch
- Amber
- Optronics
more information >
Continue Researching
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Charge a Dump Trailer Battery
- Article: Trailer Wiring Diagrams
- Q&A: Can Trailer 4-Way be Ran to Trailer with 8 Wires for Trailer Wiring
- Q&A: How to Replace a 4-Way Trailer Connector with 8 Wires
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Recommended Lithium Battery Compatible Power Converter For Parallax 7355
- Q&A: Difference Between Trailer Tire Sizes ST205/75R15 and ST225/75R15
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Grease Seal to Replace 127194TB
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Hitch Receiver Sizes