Will Dexter Brake Assembly Set 23-47-48 Fit Snowmobile Trailer with Close to 3 inch Bolt Pattern
Question:
I’m trying to swap hydraulic brakes on my 4 place snowmobile trailer to electric brakes and I couldn’t find what the bolt pattern for the backing plate which this kit fits. I measured mine and it was roughly 3 inch spacing horizontally. The brake kit I’m looking at is the Dexter Electric Trailer Brake Kit - 7inch - Left and Right Hand Assemblies - - 2,000- to 2,200-lbs - 23-47-48 Could you confirm this kit would fit my trailer? It has 2,000 pound axles with a tire size of 20.5 8-10
asked by: Jacob S
Expert Reply:
The dimensions you mentioned are standard for brake assemblies so yes the Dexter assembly set part # 23-47-48 would work
Product Page this Question was Asked From
Dexter Electric Trailer Brakes - 7" - Left/Right Hand Assemblies - 2,000 lbs to 2,200 lbs
- Trailer Brakes
- Electric Drum Brakes
- Standard Grade
- Manual Adjust
- 7 x 1-1/4 Inch Drum
- 2000 lbs Axle
- 2200 lbs Axle
- 10 Inch Wheel
- 12 Inch Wheel
- 13 Inch Wheel
- Dexter
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Adding Trailer Brakes to a Little Guy Meerkat Trailer
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Are Bearings L44549 and L44649 Interchangeable
- Q&A: How to Measure to Determine the Size Trailer Brakes Needed For Hydraulic Drum Replacement
- Article: Most Popular Wheel Bearings
- Article: Trailer Tire Sizing
- Q&A: Recommended Spring Seat for a 2,200 lbs Axle w/ a 1-3/4" Diameter
- Q&A: Best Tire to Replace a Goodyear ST185/80R13 Tire With
- Q&A: How do You Determine If a Trailer Brake Magnet is Worn Out
- Q&A: Testing Electric Trailer Brakes Using Direct Battery Power
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers