How To Pair A Voyager WiSight 2.0 Camera And Monitor Together

Question:

Tried 30 times or so while driving back home on the last trip I was on and could NOT get the WiSight to pair. Only thing I found from the bloggers is that you must 1st shut off the Tow vehicles lights and then while pairing, you can turn them back on. Is this correct or am I missing something?

asked by: Mark R

Expert Reply:

The camera for the Voyager WiSight 2.0 Wireless Backup Camera System # ASA24YR can not be powered until the monitor is powered and ready to pair, which is why you saw that the headlights need to be turned off to stop power from reaching the camera. I've added the instructions below to walk you through the pairing process.

1. Make sure the monitor is connected to 12 Volt DC power supply, but 12 Volt DC power is removed from the camera (clearance lights turned off).
2. Press the SEL/PAIR button on the front of the monitor expected mode & select the appropriate AV source.
3. Press and hold the "SEL/PAIR" button on the front of the monitor for 5 seconds and release. (Monitor will display "PAIRING")
4. Apply 12 Volt DC power to the camera (turn on the clearance lights). If pairing multiple cameras to the system, make sure that only the only the corresponding camera (Camera 1 –Camera 4 corresponding to Monitor's CH1- CH4) has power when pairing.
If done correctly, the monitor will display "PAIRING SUCCESSFUL". If pairing is not successful, the monitor will display "PAIRING FAIL". If you receive this message, repeat steps

expert reply by: Kevin C