Troubleshooting Lippert Linc Remote Not Connecting To Receiver on 2012 Keystone Montana Mountaineer
Question:
I could use some help syncing my remote on my 2012 Montana Mountaineer. I followed the setup by depressing the button the receiver and when the red light came on I held down the light button on the remote meanwhile all the lights were flashing on the remote. I never got any kind of sound from the remote while doing this procedure. Also when I just push the button on the receiver and let it go ,it flashes.
asked by: Ron E
Expert Reply:
It sounds like there may be an issue with your receiver. Typically when you press an hold the button the receiver it should remain constant after 5 seconds. If you can provide me with the receiver and transmitter numbers I can verify the correct process for connecting them on your 2012 Keystone Montana Mountaineer.
Product Page this Question was Asked From
Replacement New-Style Linc Analog Remote - 5 Function
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Remote Control
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How to Sync the Lippert Remote Part # LC358601 to the Multi-Function Pad
- Q&A: Motor Replacement for Kwikee Step Motor Number 903209000
- Q&A: How to Sync the Lippert Linc Analog Remote
- Q&A: Does the Replacement 5-Function Remote Receiver with Replaceable Fuses # LC305117 Work w OneControl
- Q&A: Manual for Lippert Replacement New-Style Linc Analog Remote
- Q&A: How To Choose the Correct Length of TorkLift SuperTruss Hitch Extension
- Q&A: Solution for Needing Higher Capacity Hitch Extension for 2021 Ram 3500
- Article: Trailer Tire Sizing
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: My Trailer Hitch Doesn't Fit