Removing Rust from Metal Trailer Fenders For Paint Prep
Question:
I did not paint when install now as little surface rust whats best way to prep to paint stop the rust
asked by: John R
Expert Reply:
The trailer fender part # HP36VR that you referenced is raw steel so it's going to rust if it's exposed to moisture. When you go to paint yours I would take some steel wool to the rusty areas to get it all off and then prime and paint it whatever color you like and you'll be good! You might even see if you can find a spray paint that has a primer in it already to eliminate that step. Most paints are good to use on metal surfaces too so it shouldn't be super hard to find what you would need.
Product Page this Question was Asked From
Single Axle Trailer Fender w/ Backing Plate - Steel - 14" to 15" Wheels - Qty 1
- Trailer Fenders
- No Step
- 14 Inch Wheels
- 15 Inch Wheels
- 9 Inch Wide
- 32 Inch Long
- Steel
- Bolt-On
- Weld-On
- For Single-Axle Trailers
- etrailer
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: Flat Towing Package for 2016-2017 Ram 1500
- Article: Trailer Tire Sizing
- Q&A: Replacement Fender for 2017 Forest River R-Pod 179
- Q&A: What is the Height and Width of a 205/75-15 Tire on a 15 Inch Trailer Wheel
- Q&A: Comparing Curt Echo And Tekonsha Prodigy RF Wireless Brake Controllers
- Q&A: Largest Recommended Wheel and Tire For Use With Timbren Axle-Less Trailer Suspension # A20RS545
- Article: Where to Position the Trailer Axle?
- Article: Overview of Lubricating Grease
- Article: Rooftop Cargo Carriers
- Q&A: Overall Dimensions of the Hangers in Single-Axle Trailer Hanger Kit APS1
- Q&A: Comparing the Single-Axle Trailer Hanger Kits for Double-Eye Springs APS1, APS2, and APS3
- Q&A: Recommended Double Eye Leaf Springs and Hanger Kit for 3,500 Pound Axle Trailer