How Does the Dutton-Lainson StrongArm Electric Winch # DL24876 Install
Question:
Is there a generic mounting plate or any other mounting hardware included with this winch?
asked by: Stephen C
Helpful Expert Reply:
The Dutton-Lainson StrongArm Electric Winch # DL24876 that you referenced is equipped with keyhole slots in the base for use with quick mounting shoulder studs if desired. They would need to be mounted securely into the winch stand of where you plan on installing the winch. After positioning the winch on the studs, a 3/8 inch bolt should be placed in one of the other holes available to keep the winch secure in position.
All of the mounting hardware needed will need to be supplied by you.
I attached installation instructions for you to check out also.
Product Page this Question was Asked From
Dutton-Lainson StrongArm Electric Winch w/ Pulley Block, AC Powered - 2,700 lbs
- Electric Winch
- AC Winch
- Spur Gear
- 2001 - 4000 lbs
- 31 - 40 lbs
- Slow - 0 to 4 fpm
- No Remote
- Wire Rope
- Dutton-Lainson
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Dutton-Lainson 90-946 100VDC 7.7 Motor
- Q&A: How Does the Dutton-Lainson Electrical Quick Connect # DL24086 Wire Up
- Q&A: Will The Replacement Bridge Assembly DL92QR Work With A Dayton Winch?
- Q&A: Dutton-Lainson TW4000 StrongArm Electric Winch # DL25200 Shuts Down When Under Load
- Q&A: Mounting Bracket for Winch Quick-Connect Wiring
- Q&A: How to Power Dutton-Lainson Winch # DL25200 with 2008 Chevy TrailBlazer
- Q&A: Where is the Bulldog Winch # BDW15018 Manufactured?
- Article: Finding the Right Electric Winch
- Article: How to Choose the Best Winch for You, your Boat, and your Trailer
- Article: Trailer Jacks