Troubleshooting Out of Stroke Error Code of Lippert Ground Control RV 3.0
Question:
I have a Lippert Leveling system on my RV it’s throwing a code that says out of stroke right side how do I fix that
asked by: Candy
0
Expert Reply:
To clear your out of stroke error you will just need to manually extend or retract all of the jacks 6", then hit the retract button on the control panel.
This is typically due to the ground where the camper is parked not being level.
If one jack has to extended multiple inches further that another then it will cause this error, and could be why the issue is only happening intermittently.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 6 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Hole To Hole Dimensions For Replacement I-Beam Jack Bracket # LC349975
- Q&A: Solutions To Add More Clearance For Lippert Ground Control 3.0 Jack Legs
- Q&A: Is The Pad For The Replacement 22-1/2" Legs For The Ground Control 3.0 Welded Or Pinned In Place
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Wiring Diagram and Fuse Location for the Lippert Ground Control 3.0 4-Point Leveling System
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Wiring Installation for 5th Wheel Landing Gear Switch
- Q&A: Wiring Guide for Installing 5th Wheel Landing Gear Motor Switch
- Article: The Best 5th Wheel Hitches
- Article: No Missteps Here: Best Camper and RV Steps (2022)
- Article: Best 2020 Heavy Duty Trucks for Towing a 5th Wheel
- Article: Trailer Maintenance Schedule
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs