How to Wire Up the Third Brake Light of a Truck Canopy on a 2009 Chevy Silverado 1500
Question:
2009 chev siverado 1500 the canopy has two wires for brake light and dome light. can you tell me how to go about wireing it. cheers
asked by: Jerry
0
Expert Reply:
For wiring the third brake light of your canopy you will want to locate the orange wire in the bundle of wires near your brake pedal that should be labeled CHMSL.
For powering the dome light you will want to use a 12 volt power source, you could use the red/black wire in the bundle you found previously as this circuit is a 12 volt power source.
Check out the FAQ article I attached that shows where this bundle is.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Pollak Replacement 7-Pole, RV-Style Trailer Connector Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 7 Round - Blade
- Pollak
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Q&A: Availability of InvisiBrake Installation Video on 1998 Jeep Wrangler
- Q&A: Replacement for Pollak PA66-MD40 Connector
- Q&A: Recommended Flat Towing Setup for a 2016 Jeep Wrangler Using a ReadyBrute Elite II Tow Bar
- Article: Flat Towing Package for 2011 Chevrolet HHR
- Q&A: Does B and W Gooseneck Hitch # BWGNRK1217 Fit 2017 Nissan Titan XD Long Bed
- Q&A: Blule Ox Baseplate For A Diesel 2020 GMC Sierra 3500 Denali
- Q&A: Replacement Connector for a Pollak PA66-MD40
- Q&A: How To Mount Pollak Connector PA66GF30