Does Hole in Side of Spindle Mean It Is an E-Z- Lube Spindle
Question:
I recently had our trailer rebuilt. The used dexter 84 axles and put on Kodiak pro oil bath lube caps all around. I’d like to know if I have easy lube spindles. There’s no zirk but the might have removed it because of the oil bath. There’s a hole in the end of the spindle, but it’s off center. There’s also a hole near the rear seal on the spindle. I’ve got photos…. Thanks.
asked by: Dave
Expert Reply:
It sounds like the holes match up to what standard Dexter Axle E-Z Lube Spindles have, like what we see with the 95" 3,500 lb axle # 7359765 (which uses #84 spindles). I'm attaching a side-view photo of this spindle for you to check out.
Oil bath hubs are supposed to run cooler than grease setups so if that's what you already have then I actually recommend sticking with it unless you're having issues with something.
Product Page this Question was Asked From
Dexter Trailer Axle Beam with E-Z Lube Spindles - 95" Long - 3,500 lbs
- Trailer Axles
- Leaf Spring Suspension
- Easy Lube Spindles
- No Hubs
- 3500 lbs
- Spindles Only
- 80 Inch Long
- 95 Inch Long
- No Drop or Lift
- Dexter
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: Pintle-Hitches
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Q&A: Correct Replacement for Quality 3500 Lb 95 HF 80 SC Trailer Axle
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: How to Measure the Bolt Pattern of a Trailer Wheel
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Picking Out Replacement Axle for Snowbear 550LHD Trailer
- Q&A: How to Check for a Bent Trailer Axle Spindle
- Q&A: Replacement 3,500 Lb Dexter Axle D4518710
- Q&A: Will the Air Lift LoadLifter 5000 Air Helper Springs # AL57341 Fit a 2024 Chevy 2500 Diesel With Fac
- Q&A: Replacement Solution for Fulton Swing Away A60 Drum Brake Actuator
- Q&A: Replacement For A Truryde RVD-H-65535 Hub