Wiring Side Cameras of Furrion Vision S System to Two Wire Clearance Lights
Question:
I want to install the Furrion Vision S side cameras with marker light to my 2023 E2W Alta 2810KIK. I have an existing side marker light that only has one black and one white wire. How do I connect the multiple wires on the camera light to this?
asked by: Leslie
Expert Reply:
The black wire of your current side marker light would be the power wire for the running light circuit and the white wire would be the ground. The side cameras of the # FCE48TASL-07 have a power and ground for the camera and the light so you would need to run them together.
Products Referenced in This Question
Furrion Vision S Wireless RV Observation Camera System w/ Side Marker Light Cameras - 7" Screen
- RV Camera System
- Backup Camera
- Observation Camera
- Built-In Microphone
- Touch Screen
- Anti-Glare
- Night Vision
- Motion Detecting
- Waterproof
- Wireless Signal
- 120 Degrees
- Dashboard Pedestal Mount
- Suction Cup Mount
- Below Rear Clearance
- Side Marker Lights
- 7 Inch Display
- 3 Cameras
- Furrion
more information >
Product Page this Question was Asked From
Furrion Vision S Wireless RV Observation Camera System w/ Side Marker Light Cameras - 7" Screen
- RV Camera System
- Backup Camera
- Observation Camera
- Built-In Microphone
- Touch Screen
- Anti-Glare
- Night Vision
- Motion Detecting
- Waterproof
- Wireless Signal
- 120 Degrees
- Dashboard Pedestal Mount
- Suction Cup Mount
- Below Rear Clearance
- Side Marker Lights
- 7 Inch Display
- 3 Cameras
- Furrion
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Hub And Drum Replacement for 90865 Rockwell Hub and Drum
- Article: Trailer Maintenance Schedule
- Q&A: Troubleshooting 6 Gallon Atwood Water Heater Not Working on Electric But Works on LP
- Q&A: Location of Heating Element on Atwood GC6AA-10E Water Heater
- Q&A: How to Determine if Trailer Axle is Not Aligned and How to Measure to Replace Trailer Axle
- Q&A: Best Weight Distribution for a V-Nose Trailer with Short Frame Distance from Coupler to Body
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Roof Vent Cover for Lid Marked AS-13M-VDO449 ANS Z26 1
- Q&A: What Stops Porpoising on Tow Vehicle that is Using Weight Distribution with Trailer
- Article: RV Pre-Departure Checklist
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Stability Control for Heavy Duty Vehicles
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)