How To Remove Old Cup Holder In 2021 Momentum 320G To Install Replacement Cup Holder 195-387597
Question:
How do I get the cup holder out of 2021 momentum 320g
asked by: Sue
0
Expert Reply:
To remove the Replacement Cup Holder # 195-387597 In your 2021 Momentum 320G you need to twist the top ring to remove it, and that will reveal 3 screws to be removed allowing you to completely remove the cup holder and replace it with the new one.
expert reply by:
Samuel C
0
Product Page this Question was Asked From
Replacement Cup Holder for Thomas Payne Momentum Recliners and Sofas - Qty 1
- Accessories and Parts
- RV Couches and Chairs
- Cup Holders
- Thomas Payne
more information >
Continue Researching
- Q&A: Replacement Lens for Glo-Brite 122R and 122Y
- Q&A: Correct Replacement Actuator for a QDPT-01-002 Actuator
- Q&A: Replacement for High Pointe RV Microwave and Trim Kit
- Q&A: Does Roadmaster Spare Carrier # RM-195125 Fit Hitch of 2020 Ford E-450 Class C
- Q&A: Troubleshooting A Thomas Payne Recliner That Will Not Recline
- Q&A: Troubleshooting A Thomas Payne Recliner That Has Lights That Don't Turn Off
- Q&A: How to Remove Cup Holder from Thomas Payne Momentum RV Dual Reclining Sofa
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: 2022 Best Stocking Stuffers
- Article: We Used 34 RV Tow Bars, and These are the Best for Flat Towing
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Brake Controller Installation: Starting from Scratch