3-Wire to 2-Wire Converter For Connecting Mack Dump Truck To Trailer With 7-Way Blade Connector
Question:
I have a Mack granite dump truck with separate tail light and brake light wiring. I would like to use my electric brake trailer with the seven blade but has the turn signal and brake light trailer together. is there a way to convert this. I wired an electric brake controller for the truck everything works except this issue.
asked by: Amir A
0
Expert Reply:
The Hopkins Tail Light Converter # HM48847 will need to be wired in line of your 7-way. This will take the 3 wire brake lights and turn signals and convert them to a 2 wire system like that used on your trailer.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Hopkins Tail Light Converter - LED Compatible
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 3-to-2 Converter
- Hopkins
more information >
Continue Researching
- Shop: Vehicle Tow Bar Wiring
- Shop: Trailer Wiring
- Shop: Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Shop: Hopkins Endurance 4-Way Flat Trailer Connector w/ 48" Harness and Ergonomic Pull
- Shop: Hopkins Endurance Quick-Fix Replacement 4-Way Flat Trailer Connector w LED Test Lights - Vehicle End
- Shop: Hopkins Trailer Connector Adapter - 7-Pole Round Pin to 7-Pole RV
- Shop: Base Plate for Tow Bar
- Video: Roadmaster Tow Bar Wiring RM-300150-00 Review
- Shop: Roadmaster Extension Loop for Towed Vehicles - Dual 4-Way Flat Trailer Ends - 6' Long
- Search Results: circuit tester
- Search Results: jumper harness
- Search Results: 4 flat male to 4 flat male
- Search Results: 30717
- Video: Hopkins Wiring - Wiring Adapters - HM47180 Review
- Video: Hopkins Wiring - Wiring Adapters - 47405 Review
- Search Results: 47465
- Video: Roadmaster Tow Bar Wiring RM-164-7 Review
- Shop: Hopkins Endurance Multi-Tow 4-Way Flat to 7-Way RV Trailer Adapter w/ 4-Way Vehicle End Plug
- Shop: Adapter 4-Pole to 7-Pole and 4-Pole
- Search Results: 7 wire to 6 wire
- Search Results: roadmaster 7 wire to 4 wire flexo coil
- Q&A: Converter Recommendation for Vehicle with Separate Turn Signals from Stoplights for Wiring to 7-Way
- Q&A: Converting Separate Tail Light Circuits to Combined to Use an LED Light Bar with Brake, Turn, Tail
- Q&A: Converter Needed to Go From Combined Circuit to Combined
- Q&A: Brake Wire Backfeeding to Light on 7-Way
- Q&A: Can Separate Turn Signals be Bypassed on Trailer Wiring for Stop/Turn Circuit
- Q&A: Is Converter Needed to Go From 7-Way Round to 7-Way Flat
- Q&A: Adapter Recommendation for Going from 7-Way Round to Flat
- Video: Deka Jacketed 6-Wire Installation
- Video: Hopkins Wiring - Trailer Connectors - HM48440 Review