2-Wire to 3-Wire Tail Light Converter For Connecting 2003 Lance Truck Camper To 7-Way Blade
Question:
Good afternoon, and thanks for advance you assistance. My wife and I have recently purchased a 2003 lance truck camper. We have been placing orders through etrailer. My question: the lance camper we purchased had a 7 round pin style connection , however that was not compatible with our purchased Item # 50-97-410 7 blade connection. Due to this incompatible I converted the lance camper 7 round connection into a 7 blade connection, however I am unable to wire the conversation correctly to make the lights on the truck camper to respond correctly. To my best ability I have followed wiring diagrams but still miss the mark . I’ve read the QandA converting from 7 way round to 7 way connector . Maybe I need to order item 119130 to allow this to be converted correctly?
asked by: Austin
Expert Reply:
A 7-way blade connection will combine the turn signals and brake lights where a 7-way pin connection keeps these functions separate. A Curt 2 to 3 Wire Tail Light Converter # C56196 is needed to separate these functions back to 3 separate wires. Do note this will not work if the lights on your Lance are LED. For LED lights you will also need to add Resistors # P230004A to each circuit so there is enough power draw to trick the circuit. I have included an image below with the wiring points for both 7-ways.
Products Referenced in This Question
Putco LED Light Bulb Load-Resistor Kit - Aluminum
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Aluminum
- Putco
more information >
Product Page this Question was Asked From
Curt 2 to 3 Wire Tail Light Converter
- Tow Bar Wiring
- Splices into Vehicle Wiring
- Tail Light Converter
- Universal
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Replacement Top Cover for Lippert Electric Trailer Jack - Black
- Shop: Pollak 6-Pole, Round Pin, Trailer Wiring Connector - Trailer End
- Search Results: pk11604
- Shop: Trailer Wiring
- Shop: Replacement 12-Volt Battery for Curt Soft Trac I and II Trailer Breakaway Kits
- Shop: Replacement 12V 5 Ah Battery for Bright Way Trailer Breakaway Kits
- Shop: Gooseneck Hitch
- Shop: Miro-Flex LED Clearance or Side Marker Light w/ Reflector - Submersible - 9 Diodes - Red Lens
- Search Results: mcl50rb
- Shop: Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black
- Q&A: Troubleshooting Trailer Brake Lights that Do Not Work When Parking Lights are Switched On
- Shop: Vehicle Tow Bar Wiring
- Search Results: trailer wheel
- Shop: Double Lip Grease Seal - ID 1.249" / OD 1.983" - Qty 1
- Search Results: 61100
- Search Results: gnxa2061
- Search Results: lc285160
- Shop: Windshield Covers
- Video: etrailer.com Exterior Windshield and Wiper Blade Cover Comparison
- Search Results: pd4135kw2bv
- Q&A: What is the Weight Capacity and Pressure Rating for Dexstar Steel Spoke Trailer Wheel, # AM20522
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: How to Determine if Trailer Axle is Not Aligned and How to Measure to Replace Trailer Axle
- Q&A: Best Replacement for Old 6.00-16 Trailer Tires
- Q&A: Replacement Oil Cap for Dexter Hub # 21-35
- Q&A: Replacement Amber Lens for Trailer Light with SAE A P2 DOT 14
- Article: Trailer Wiring Diagrams
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: How to Measure a Trailer Axle
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)