What Size Screws Are Included With The Valterra RV Sewer Hose Carrier
Question:
What size drill bit do I need for the 6 self tapping screws? The instructions do not provide that information. Thanks,
asked by: Jeff S
0
Expert Reply:
The screws included with the Valterra RV Sewer Hose Carrier # A04-5094BK are #14 x 1" self-tapping screws and would require either a 10mm or 3/8" socket in order to drive them into the trailer frame. Since these are self-tapping you would not need to drill out a hole first for the screw to bite through. If you wanted to go with a beefier screw you can pick up additional ones at your local hardware store.
expert reply by:
Kevin C
0
Product Page this Question was Asked From
Valterra RV Sewer Hose Carrier - Adjustable - 50" to 94" - Black
- RV Sewer Hose Support
- Hose Carrier
- Plastic
- 50 - 94 Inch Long
- Black
- Valterra
more information >
Continue Researching
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Article: Trailer Wiring Diagrams
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Q&A: Which Nev-R-Adjust Brake Assemblies for Load Trail 14K Dump Trailer
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Q&A: Replacement Amber Lens for Trailer Light with SAE A P2 DOT 14
- Article: Best Camper Jacks
- Q&A: How to Tell if a Vehicle has a Tow Package or Not
- Article: Trailer Tire Sizing
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How Much Solar Power Do I Need For My RV?
- Article: Best Vehicles to Flat Tow Behind an RV