Replacement For Fulton 1,500 lb Bolt-On Trailer Jack
Question:
I have a Fulton 1500# bolt on trailer jack that is extended to the full height position but will not retract. I can only rotate the handle about a 1 in either direction. I cannot remove the gear pin because the pin is not in a position to do so. Is there any recommendations to resolve my issue?
asked by: John D
1
Helpful Expert Reply:
Yes, you will need to replace your Fulton 1,500 lb bolt-on trailer jack, and can do so with the Fulton Bolt-Thru Swivel Marine Jack with Dual Wheels - Sidewind - 12" Lift - 1,500 lbs # FXPD15L.
expert reply by:
Kyle S
1
Product Page this Question was Asked From
Fulton Boat Trailer Jack w/ 2 Wheels - Sidewind - Swivel - 12" Lift - Zinc - 1.5K
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 12 Inch Lift
- Bolt-On
- With Wheel
- Fulton
more information >
Continue Researching
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Can Electric Trailer Brake Kit # AKEBRK-2 be Submerged in Water
- Q&A: Brake Controller and 7-Way Install on 2013 Chevy Express w/ Tow Pakage
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Q&A: Can I Use Different Grease w/ the CE Smith Trailer Idler Hub Assembly?
- Q&A: Replacement Strut for Stabilus Lift-O-Mat on Dometic Awning
- Article: Trailer Wiring Diagrams
- Q&A: 25-1/4 Inch or 26 Inch 4,000 lb Double-Eye Spring For Trailer With 25-1/2 Inch Eye Spacing
- Article: Trailer Maintenance Schedule
- Article: Trailer Tire Sizing
- Q&A: Do Trailer Jacks with Two Wheels Make it Easier to Maneuver a Jack on Concrete
- Article: Most Popular Wheel Bearings
- Article: Trailer Jacks