Where to Install Solenoid and Circuit Breaker for Superwinch LT 2000 on a 2010 Polaris Sportsman 500
Question:
Where would the solenoid and circuit breaker mount on a 2010 Polaris Sportsman 500 HO?
asked by: Jim
1
Helpful Expert Reply:
Typically, you will mount the solenoid and breaker under the seat where the battery is or on the frame in this same general area. I have included a link to a video showing a typical installation of Superwinch LT2000 on a 2012 Polaris that you can use as a guide.
expert reply by:
Michael H
1
Product Page this Question was Asked From
Superwinch LT2000 ATV Winch - Wire Rope - Roller Fairlead - 2,000 lbs
- Electric Winch
- ATV - UTV Winch
- 1-Stage Planetary Gear
- 1.0 HP
- 1001 - 2000 lbs
- 11 - 20 lbs
- Slow - 0 to 4 fpm
- No Remote
- Wire Rope
- Superwinch
more information >
Continue Researching
- Q&A: Recommended Electric Winch for Raising and Lowering a Pop Up Camper
- Q&A: Finding A Replacement Electric Winch For 2007 Rockwood Popup Camper
- Q&A: Electric Winch Recommendation for Forest River Pop Up Camper
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Can Pop Up Camper Trailer Hand Winch be Replaced with Electric Winch
- Q&A: Difference Between an Idler Hub and a Hub/Drum
- Q&A: Installation of the Remote for the Superwinch LT2000
- Q&A: Can 15 inch Wheels be Used with a 2,000-lb Trailer Axle
- Article: Basics of Tie Down Straps
- Article: Trailer Hitch Receiver Sizes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Using a Portable Generator on RV