Does Power Wire of Redarc Manager30 Need to Run Directly to Battery
Question:
In the Redarc Manager30 manual, it states to connect the Battery Sensor positive lead connector to the house battery positive terminal. Does it have to be connected to the battery terminal directly or can it be connected to a positive bus bar that is directly connected to the positive terminal?
asked by: Greg P
0
Expert Reply:
The brown wire of the Redarc Manager30 # RED93FR does need to run to the positive battery post directly through a 40 amp fuse. It might work fine if ran to a bus bar but it would need to have at least 40 amps available there for the Manager30 to work.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Redarc The Manager30 Battery Management System with Lithium Profile and Color Display - Bluetooth
- Battery Charger
- Battery Charger
- Boat
- RV/Camper
- Trailer
- Charges/Maintains
- 12V
- Solar Panels to Auxiliary BAttery
- Vehicle Battery to Auxiliary Battery
- Redarc
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Amperage/Wattage Max Input for The Manager30 Battery Management System
- Q&A: Max Wire Gauge That The Manager30 Battery Management System Uses
- Q&A: Troubleshooting A MaxxAir MaxxFan 4050K That Won't Run
- Q&A: What Size Fuse Kit to Use with Redarc Manager30 Kit
- Article: What is Boondocking
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Q&A: Center to Center Eye Measurement of B355 Roadmaster Endlinks Included in Kit RM-590170-00
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Q&A: What Size Trailer Hub Drums will Fit Behind 10 Inch Trailer Wheel
- Article: How Much Solar Power Do I Need For My RV?
- Article: Best Camper Jacks
- Article: How Long Can You Boondock in an RV?
- Article: Yes, You Can RV Alone: 5 Safety Tips for Solo Campers