PD4560K18LS8 No Output to DC Side
Question:
Just got my PD4500 installed on a new build. Connected the DC side to battery power to test out some circuits after grounding the unit, and I have no output to the DC side. LED status light blinks about one time per second but I have no power beyond that. Individual LED circuit lights are not lit. Any advice? If it matters, I do not have anything installed to the AC side. Thanks.
asked by: Erik
Expert Reply:
Per the instructions of the # PD4560K18LS8, if there is no output, there are a number of potential issues. One is the AC distribution panel, one is the reverse battery connection (if they are connected in reverse, even momentarily, they will blow), one is a blown circuit, and another is the output mode switch not being on.
Product Page this Question was Asked From
Progressive Dynamics 4500 Series RV Converter w/ Charge Wizard and AC/DC Distribution Panel - 60 Amp
- RV Converters
- Smart Charge
- Standard Charge
- 10-1/8L x 13-1/4T Inch
- 12V
- 60 Amps
- Lead Acid
- Lithium
- Progressive Dynamics
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacing American CS6000XL in Camper
- Q&A: WFCO WF-9960 Replacement Converter
- Q&A: Replacement for Parallex 500 Series Model 555 Converter
- Q&A: Recommended AC With Heat Strip for Enclosed Trailer
- Q&A: PD4560LICSV Converter and Power Control Center PD4560K18LS8
- Q&A: Solution for Replacing American CS6000XL in RV
- Q&A: Replacement Power Converter for WFCO-8560
- Article: Trailer Tire Sizing
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Trailer Wiring Diagrams
- Article: 4-Step Guide to Installing RV Solar Power
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Best RV Roof Vents