Recommended Mounting Hardware and Thickness of Optronics Trailer Reflector # RE35RB
Question:
What is the recommended mounting hardware for this reflector? Also, how thick is it?
asked by: Jake M
1
Helpful Expert Reply:
The screw hole of the Optronics Trailer Reflector, # RE35RB, is 1/4 inch in diameter. There is also a small lip that is 3/8 of an inch in diameter (see photo). Optronics does not recommend a specific type of fastener so you could use any type of screw you would like. I would recommend using a stainless steel screw because it will hold up the best against the elements.
This reflector is 0.22 inches thick, or just smaller than 1/4 of an inch.
expert reply by:
John H
1
click to enlarge
Product Page this Question was Asked From
Screw Mount Reflector for Truck or Trailer - 2-3/16" Round - Red - Qty 1
- Trailer Lights
- Reflectors
- Round
- Surface Mount
- 2-3/16 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: What is the Difference Between Load Range B and C Trailer Tires
- Q&A: Replacement Taillight Options for 1967 Airstream Caravel Trailer
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Q&A: Availability Of 12" Replacement Brakes For Kelsey Hayes 4-Bolt Pattern With 3-1/2" Center Hole
- Article: Best Bike Racks for Electric Bikes
- Q&A: Recommended Brake Controller and Wiring for 2021 Jeep Grand Cherokee
- Q&A: Where is the Stop Light Switch Wire on a 2023 Jeep Grand Cherokee L
- Q&A: Curt Brake Controller Adapter Harness for a 2020 Jeep Grand Cherokee
- Q&A: Parts Needed To Install Curt TriFlex Trailer Brake Controller In 2021 Jeep Grand Cherokee W/ Tow Pkg
- Article: How Much Solar Power Do I Need For My RV?
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)
- Article: Rust Prevention
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices