Will Curt Front Hitch # 31180 Fit 2004 Toyota Sequoia
Question:
will this part also fit my vehicle as I think the Tundra has the same chassis as my car. Thanks
asked by: Eden J
Expert Reply:
The Curt Front Hitch, part # 31180, is a fit for your 2004 Toyota Sequoia. This hitch has an easy, no-weld installation and is designed to be a specific fit for your Sequoia. This 2 inch receiver hitch can accommodate several accessories like a spare tire carrier, a winch, or a snowplow.
You always want to follow the vehicle manufacturers recommendations for weight capacity when installing a hitch.
We also carry a rubber cover, part # C22272, for this hitch. This keeps debris out of the hitch opening when you are not using the hitch.
Products Referenced in This Question
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 500 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is Drilling Required to Install a Front Mount Trailer Hitch on a 2006 Toyota Tundra
- Q&A: Does Skid Plate have to be Removed or Any Trimming to Install a Front Hitch on 2006 Toyota Sequoia
- Q&A: Does Skid Plate Have to be Removed to Install Draw-Tite Front Hitch on 2005 Toyota Tundra
- Q&A: Front Hitch Recommendation for a 2002 Toyota Tundra
- Q&A: What are the Dimensions of the Yakima EXO Swing Away Rack
- Q&A: What is the Total Height of the Yakima Exo Swing Away Storage System # Y74ZR?
- Q&A: Battery Charger for a Trailer Battery on a Dump Trailer
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Hitch Installation Tips
- Article: How to Manually Light an RV Oven, Furnace, Water Heater, or Refrigerator
- Article: Determining Trailer Tongue Weight
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Performance Chips and Modules