How Long is the Top Part of the Tandem Axle Jeep Style Trailer Fenders
Question:
The fenders are 72inch long at the bottom. Can you provide me with a measurement along the flat top portion of the fender?
asked by: Peter
0
Expert Reply:
I went out to our warehouse for you and measured the Tandem Axle Jeep Style Trailer Fenders part # HP62VR. The top part has a radius at each end so there isn't exactly a set point to measure from but I did my best to get the center of the radius and I found this to be around 54".
I have attached a photo below with this info.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Tandem Axle Jeep Style Trailer Fenders - Cold Rolled Steel - Qty 2
- Trailer Fenders
- No Step
- 10 Inch Wide
- 72 Inch Long
- Steel
- Bolt-On
- Weld-On
- For Tandem-Axle Trailers
- etrailer
more information >
Continue Researching
- Shop: Tandem Axle Jeep Style Trailer Fenders - Cold Rolled Steel - Qty 2
- Q&A: Replacement For A Truryde RVD-H-65535 Hub
- Q&A: Trailer Hub Wont Slide Onto the Spindle of a Timbren Axle-Less System
- Shop: Dexter Nev-R-Adjust Electric Trailer Brakes - 10" - Left/Right Hand Assemblies - 3.5K
- Shop: Easy Grease Trailer Hub and Drum Assembly for 3.5K Axles - 10" - 6 on 5-1/2 - Pre-Greased
- Shop: Dexter Trailer Axle Beam with E-Z Lube Spindles - 95" Long - 3,500 lbs
- Search Results: trailer jeep style fenders
- Video: Review of etrailer Trailer Fenders - Tandem Axle Jeep Style Trailer Fenders - HP62VR
- Q&A: Calculating Tire Capacity for a Trailer with a Tandem, Dual Axle
- Q&A: Can 7/16" U-Bolts be Used for 3,500 lb Axle Suspension
- Search Results: leaf spring kit
- Search Results: axle
- Search Results: hanger kit
- Search Results: trailer light kit
- Search Results: demco coupler
- Search Results: leaf spring
- Shop: Kenda Karrier ST225/75R15 Radial Tire with 15" Black Galvstar - 6 on 5-1/2 - Load Range D
- Shop: Dexter Trailer Axle Beam with E-Z Lube Spindles - 94" Long - 7,000 lbs
- Shop: Trailer Axle w/ Electric Brakes - Easy Grease - 6 on 5-1/2 Bolt Pattern - 95" Long - 5,200 lbs
- Video: Demco eZ-Latch A-Frame Trailer Coupler Review and Installation
- Q&A: How to Determine Frame Width When Building Trailer with 7K Axles
- Q&A: How to Measure the Angle of Trailer A Frame To Determine if a 50 Degree A Frame Coupler will Fit
- Q&A: What is the Torque Requirement for 1/2 Inch U-Bolts for Trailer Suspension
- Shop: Fender Flares
- Shop: Trim Kits