How to Remove GloLight Uni Lite without Access to Back of Light
Question:
Good Evening, How do I remove my current 3/4” clearance light on my Class A RV, if I do not have access to the back of the light? Similar to Item # MCL110RKB Sincerely,
asked by: Clint
0
Expert Reply:
The GloLight Uni-Lite LED Clearance and Side Marker Light # MCL110RKB that you referenced is designed to remove by being pushed out from behind the light. Without access to the back you could try gently prying it out with a small slot screwdriver to see if that might work. Soapy water goes a long way with these grommet lights as far as a lubricant to help coax them out.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
GloLight Uni-Lite LED Clearance and Side Marker Light - Submersible - 2 Diodes - Round - Red Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 3/4 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: What is the Approximate Amperage Draw of the ST70RB Sealed Oval Trailer Light
- Article: Trailer Lighting Requirements
- Q&A: How To Determine the Correct Size Lug Nuts For a Trailer
- Q&A: Wire Gauge and Ground Locations for LED Running Lights on a Trailer
- Q&A: Availability Of LED Circuit Board Light With 906/921/194 Base
- Q&A: Replacement Bearing Set for Freedom Axle 45264 3500 lb Idler Hub
- Q&A: Replacement Hub for DICO 45264
- Q&A: Wiring Functions of Command Electronics Triple LED Tail Light for 2017 Winnebago Vista LX 27N
- Article: Double-Eye Trailer Suspension System Review
- Article: Trailer Jacks
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)