How Do You Set the Air Lift Wireless Controller To JOIN Mode?

Question:

How do you set the manifold to Join mode? The magnet will not attach to any part of the manifold where the instructions say it should.

asked by: Colin M

Expert Reply:

In order to get the manifold to go into "JOIn Mode" you are going to need to ground the yellow wire and cycle power to the manifold. So you're going to need to take the yellow wire and ground it by either connecting it to the frame, or running a wire to the negative battery post.

From here, you will need to press the up and down buttons together until the unit flashes JOIn, once it does then press the M1 button. After the M1 button is pressed, you'll just need to select the front (f) or the rear (r) manifold and you'll be all set.

expert reply by: Bryce D