What is the Width of Curt Front Mount Trailer Hitch 31180 for a 2006 Toyota Tundra
Question:
What is the width between the mounting arms of the hitch? My truck has an aftermarket skid plate which should ease installation of the hitch assuming the opening between the mounting arms is wide enough. Thanks.
asked by: Rich
Helpful Expert Reply:
I spoke with my contact at Curt and I have some measurements on hitch # 31180 for you. For the mounting holes, they are 34-3/8 inches apart on center, side to side. The width between the mounting brackets is about 31-3/8 inches. I have included a picture showing the measurements. I have also included links to the installation details and a video showing a typical installation for you.
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 500 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What is the Total Height of the Yakima Exo Swing Away Storage System # Y74ZR?
- Q&A: What are the Dimensions of the Yakima EXO Swing Away Rack
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Does Trim or Exhaust Need to be Modified to Install EcoHitch on 2021 Toyota Highlander
- Q&A: Bracket and Hitch Tube Dimensions of Ultra-Fab Trailer Hitch # UF35-946403
- Q&A: Will Ultra-Fab RV Trailer Hitch Receiver Extend Past Rear Bumper On Winnebago 2106 Trailer
- Q&A: How To Tell If Parts Are Missing From Rear Panel Extang Solid Fold Tonneau Cover That Blew Off Truck
- Q&A: Replacing Clamps on Extang Solid Fold Tonneau Cover
- Article: Trailer Hitch Installation Tips
- Article: How to Manually Light an RV Oven, Furnace, Water Heater, or Refrigerator
- Article: Determining Trailer Tongue Weight
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Performance Chips and Modules