How to Replace the Header Seal on the TruXedo Lo Pro Soft Roll-Up Tonneau Cover
Question:
Is there a video to show how to replace the bulkhead seal on the Trudexo Lo Pro?
asked by: Brent K
Expert Reply:
There is not a video out that shows you how to remove and replace the Replacement Header Seal for TruXedo Lo Pro Soft Roll-up Tonneau Cover # TX1704787 however it really is quite simple to do.
All you're going to need to do is remove your current seal by pulling the plug on the end of the header. You might find it easier to use something like a rubber mallet & a screwdriver to gently tap the seal at an angle to remove it.
Once the seal is removed, all you'll need to do is slide the replacement seal in the groove, put the end cap back and you'll be all set.
Product Page this Question was Asked From
Replacement Header Seal for TruXedo Lo Pro Soft Roll-up Tonneau Cover - 5-1/2' Long
- Accessories and Parts
- Tonneau Cover
- Header Parts
- TruXedo Lo Pro
- Seals
- Truxedo
more information >
Continue Researching
- Q&A: Recommended Tailgate Gasket For A 2022 Ram 1500
- Q&A: Truxedo Lopro Shur Bond Replacement Velcro
- Q&A: Is the Truxedo Replacement Tonneau Cover Hook and Loop Fastener # TX1115174 Adhesive Backed
- Article: Hard Tonneau Covers vs Soft Tonneau Covers
- Q&A: Do You Have an Installation Video for the Replacement Safety Straps # TX1118184?
- Q&A: Replacement Tarp for Truxedo Lo Pro QT for 2006 Toyota Tundra 6 Foot Bed with Bed Caps
- Q&A: Replacement TruXedo Lo Pro QT Tarp for a 2004 Toyota Tundra with the 6-1/2 Foot Bed
- Q&A: Tailgate Seal Compatibility For A 2023 Toyota Tacoma
- Article: How to Choose the Best Tonneau Cover
- Article: Performance Chips and Modules
- Article: Testing Brake Controls
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)