Measurements of Mounting Flange Slots on Ultimate Trailer Jack # 322-RDJ-2K
Question:
What are the measurements of the mounting flange slots from the adjuster ring
asked by: Richard C
0
Expert Reply:
The slots on the Ultimate Trailer Jack # 322-RDJ-2K from the inside of the mount near the jack tube are 1/8" from the inside. The slot itself is 7/8" long putting the outer edge 1" from the jack tube. The outer tube diameter is 2-1/4" for your center mount cutout. The mounting holes should be between 3" and 3-1/4" on center to ensure this jack will fit on your trailer mounting bracket.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Topwind Jack
- 28 Inch Lift
- Bolt-On
- Weld-On
- With Rectangle Foot
- Ultimate Jack
more information >
Continue Researching
- Q&A: How to Wire a 6 Pole Round Trailer End Plug
- Article: Trailer Wiring Diagrams
- Q&A: Where Is Factory Trailer Brake Controller Port On 2021 Chevrolet Tahoe W/ Factory Tow Package?
- Q&A: Trouble Finding the Brake Controller Wiring Port on a 2019 Chevy Blazer
- Q&A: Where is the Factory Trailer Brake Controller Port On a 2022 Chevrolet Tahoe
- Article: 2023 Best Gifts for Haulers & Towers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Arms for Roadmaster EZ5 Base Plate Kit for 2015 Honda Fit
- Article: How to Charge RV Batteries
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: Seal With Dimensions to Replace 171255UC
- Article: What Exactly is Tongue Weight?
- Article: How to Measure for Trailer Hitch Drop