Rubber Cap Solution for a Momentary Push Button Switch on a RV Roof Vent
Question:
Do you sell a rubber waterproof CAP for this switch?
asked by: Howard
Expert Reply:
While there is not a rubber waterproof cap made for the Momentary Push Button Switch for RV Power Roof Vents # DG52451VP I do have another solution that'll work just the same.
All you'll need to do is use the Dexter Oil Hub Plug for 8,000-lb to 15,000-lb Hubs # 46-52 and cut either end off.
This plug has a diameter of .55" and the momentary switch has a .5" diameter making this a great fit. This rubber plug will also do a great job of creating a weather-resistant barrier between the switch and the elements.
Products Referenced in This Question
Dexter Oil Hub Plug for 8,000-lb to 15,000-lb Hubs
- Accessories and Parts
- Trailer Bearings Races Seals Caps
- Plugs
- Dexter
more information >
Product Page this Question was Asked From
Momentary Push Button Switch for RV Power Roof Vents - Normally Closed - 4" Wire Leads - Black
- Accessories and Parts
- RV Vents and Fans
- Roof Vent
- Switches
- Diamond
more information >
Continue Researching
- Article: Trailer Maintenance Schedule
- Article: What Is a Supplemental Braking System?
- Article: Must-Have Flat Towing Components
- Q&A: Brake Controller Installation 1993 Ford F350
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Direct Jensen Stereo Replacement For Older Jensen AWM965 Stereo With Same Cut Out Size
- Q&A: How To Protect A Wifi Sky Ranger 4 Antenna From RV Cover
- Q&A: Troubleshooting LED Lights on 2008 Shadow Horse Trailer
- Q&A: Recommended Replacement For A V18-233151-40 Slide Old Motor
- Article: Trailer Hitch Receiver Sizes
- Q&A: Should 3,500 lb or 5,200 lb Timbren Axle-Less System be Used for over 3,600 lbs of Loaded Trailer
- Q&A: Parts Needed to Add Disc Brakes to Timbren Axle Less Kit ASR35HDS02
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)