How To Get Rid of P.L Code on Tekonsha Prodigy P2 Trailer Brake Controller
Question:
Got a P-L code after battery replacement. Can codes be cleared ?
asked by: Dan H
0
Expert Reply:
The "P.L" error code on the Tekonsha Prodigy P2 Trailer Brake Controller part # 90885 is caused by a power interruption while the brake pedal is depressed per the owner's manual. The code should go away when the error is fixed i.e. reapplying power. If not, you will need to remove power from the brake controller via the plug on the back of the unit for a few minute and then reattach. There are no other code clearing procedures.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: Most Popular Wheel Bearings
- Q&A: Brake Controller Recommendation for a Truck with Air Brakes and a Trailer with Electric Brakes
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Parts Needed To Install A Brake Controller On A 2023 Freightliner Cascadia
- Q&A: Parts Needed to Install 7-Way/4-Way on 2024 Kia Telluride with LED Taillights
- Q&A: How do I Tell if the Brake Controller is Bad
- Q&A: Lift Kit Options For A 2015 Winnebago Micro Minnie 1706FB
- Q&A: Lug Nut Torque Chart for Trailer Wheels