Wiring Adapter Needed For Installing Draw-Tite Trailer Brake Controller On a 2020 Ford
Question:
I just traded cars and want to install my DrawTite electric brake controller into a 2020 Explorer. The car has factory 7 pin installed. I have the 3036 - P harness from my previous 2018 Ford Flex. Will that harness work? If not, what harness do I need?
asked by: Tom L
0
Products Referenced in This Question
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford, Lincoln, Mercury
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation on a Ford Full-Size Van
- Q&A: What is the Difference Between the Tekonsha Prodigy P2 and the P3 Brake Controllers
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Parts Needed To Install a 7-Way and Trailer Brake Controller On a 1996 Ford F-350 With Factory 4-Way
- Q&A: Installing A Reese Brakeman Controller In A 202 Ford E250 With Factory 4-Flat
- Article: Trailer Maintenance Schedule
- Q&A: Installing Trailer Wiring on a 2014 Ford Explorer
- Q&A: Recommended Trailer Wiring Harness for Ford E350 Van with 4-Pole Connector
- Q&A: Best Brake Controller for a 2014 Fleetwood Bounder Motorhome
- Q&A: Location of Brake Controller Wiring Connector on 2014 Fleetwood Bounder on Ford F-53 Chassis