Bolt Size for Installing Brake Pedal Clamp for InvisiBrake Supplemental Braking System
Question:
What size is the bolt need for this installation on 2019 Trailhawk?
asked by: Steve S
Expert Reply:
Thanks for reaching out!
The bolts that come with the Replacement Brake Pedal Clamp # RM-945202-00 for the InvisiBrake Supplemental Braking System # RM-8700 are labeled as 10-32 x 2 SOC HD CAP SC BL, according to my contact at Roadmaster.
You will be able to use the bolts that come with the InvisiBrake itself. If the bolt happened to break then your best bet is to take it and/or the description mentioned above to your local hardware or home improvement store to source a replacement.
Products Referenced in This Question
Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Tow Bar Braking Systems
- Brake Systems
- Pre-Set System
- One Time Set-Up
- Fixed System
- Power Assist Brake Compatible
- Air Brakes
- Hydraulic Brakes
- Roadmaster
more information >
Product Page this Question was Asked From
Replacement Brake Pedal Clamp for Roadmaster InvisiBrake Flat Tow Brake System
- Accessories and Parts
- Tow Bar Braking Systems
- Pedal Clamp
- Roadmaster
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Supplemental Braking System Recommendation for Land Rover Discovery II
- Q&A: Using The RoadMaster InvisBrake Second Vehicle Kit To Install On New Vehicle
- Q&A: Steps for Returning 2019 Jeep Cherokee Trailhawk to Normal Driving After Flat Towing
- Q&A: Where to Install Diodes when Installing Roadmaster Invisibrake with Tow Bar Lighting
- Q&A: Once a Trailer Breakaway Switch Pin has Been Pulled is the System Reusable
- Q&A: Replacement Check Valve for Roadmaster InvisiBrake Supplemental Braking System
- Q&A: Breakaway Switch Pin is Stuck in the Switch
- Article: Best Vehicles to Flat Tow Behind an RV