How Does Optronics Clearance Light MC58RB Mount and Ground
Question:
Hello, I need to replace some surface mount marker lights on my stock trailer. The current ones are 2.5 surface mount with the grounding occurring with the rivets that connect it to the trailer. I am looking at these, but I cant tell the mounting mechanism or the grounding mechanism. Can you clarify for me? I need two red and two amber. Kind regards,
asked by: John M
Expert Reply:
To mount the Optronics clearance light part # MC58RB you'll remove the lens of the assembly and run the hardware through the holes in the back of the assembly. This grounds through the mounting hardware as well. So you run power to the black wire and then once mounted it is grounded.
Product Page this Question was Asked From
2-1/2" Round Trailer Clearance and Side Marker Light, Surface Mount - Red
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Round
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 2-1/2 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: Recommended Replacement for Jensen JRV9000 RV Stereo
- Q&A: What is the Purpose of the Black Connection on the Dexter Trailer Breakaway Kit # 34-285
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: LED-Type Replacement Trailer Lights for Featherlite Enclosed Gooseneck Trailer
- Q&A: LED Trailer Taillight Recommendation for a 3110 Feather Lite Car Trailer
- Q&A: Will Bright Way Switch Mode Battery Charger Work With Optima AGM Battery
- Q&A: Troubleshooting Solera Smart Arm Power Issues
- Article: Trailer Maintenance Schedule
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure a Trailer Axle
- Article: Pintle-Hitches
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How Much Solar Power Do I Need For My RV?