Mounting Hole Dimensions of the Camco AccuLevel Trailer Bubble Level item # CAM25563
Question:
What is the mounting hole pattern on level CAM25563?
asked by: Matthew D
0
Expert Reply:
I went out to the warehouse and measured the Camco AccuLevel Trailer Bubble Level item # CAM25563. The mounting holes are 10-3/4" x 1-3/4". The holes are oblong and are a 1/2" long vertically. I took the measurements from the center of the holes.
I have linked a diagram I made below.
expert reply by:
Jerred H
0
Camco AccuLevel Trailer Bubble Level item # CAM25563
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Camco AccuLevel Trailer Bubble Level
- RV Levels
- Graduated Levels
- Manual Levels
- Screw-On
- RV Levels
- Trailer Levels
- Camco
more information >
Continue Researching
- Q&A: Can a Pop Up Camper with 8 Inch Tires be Upgraded to 10 Inch Tires
- Article: Most Popular Wheel Bearings
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Correct Backup Camera for Forest River Rockwood Mini Lite Travel Trailer
- Q&A: Weight Distribution with Sway Control for Rockwood Mini Lite 2304Ks
- Q&A: What Is The Downside Of Using an Overrated Weight Distribution Hitch?
- Q&A: How To Determine Blue Ox Spring Bar Weight Capacity
- Q&A: Replacement Coupler/Actuator For a 2002 Mastercraft Maristar 210 Boat Trailer With Drum Brakes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Importance of Trailer Wheel Pilot Hole Diameter
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs